Table of Contents
Advertisement
INSTALLATION
When mounting the camera, make sure that the
camera does not cover any part of the license
plate. Choose a position that does not impede the
access/operation of the boot release or tailgate
latch. For easy DIY installation, the cables for this
product are numbered 1 to 6. This corresponds to
the wiring diagrams on page 4 and 5 of this
manual.
STEP 1. Mounting the Monitor
1. Check the mounting position of the Monitor and
camera first before installation.
2. Ensure windscreen or dash is clean and free of
debris. Use an alcohol wipe to enhance adhesion.
3. Remove backing off 3M tape off mount and
press & hold firmly to the surface for 60 seconds.
4. Fix where the drivers vision is not blocked. Do
not install the device on airbag or within its working
range.
STEP 2. Connect Monitor Input Harness
Connect signal output cable of the monitor to the
RCA input cable.
6
Advertisement
Table of Contents
