Table of Contents
Advertisement
anytime any maintenance or repairs are done, FirSt:
1.
Disconnect the Stapler from the air hose.
2.
Empty Magazine (59, 69) completely.
3.
Attempt to fire the Stapler into a piece of scrap wood to ensure that it is disconnected
and is incapable of firing any Fasteners.
always leave Magazine Cover (72) closed during maintenance. the Magazine
4.
Cover is spring-loaded and may cause parts or a Fastener to fly out of the Stapler
if it suddenly snaps closed.
1.
Periodically lubricate all moving parts and pivots with a light oil.
2.
Wipe down the Floor Stapler with a damp cloth. Do not use harsh detergents or
solvents.
3.
Check that the Base Plate (52) and the Hammer Face (1) is clear of any dirt or
debris.
note: Have the following problems repaired by a qualified service technician.
proBleM
Air leaking in nose
Lack of Power, slow to cycle.
Intermittent feeding or no fastener
coming out
Jammed Fastener
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS
OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING
OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO,
OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 94446
For technical questions, please call 1-800-444-3353.
Maintenance
troubleshooting
CaUSe
1.
Loose Nose Screws
2.
Bumper is cracked/worn
1.
Tool is too dry
2.
Air Pressure is too low
3.
Exhaust blocked
1.
Damaged pusher spring
2.
Wrong size Fastener
3.
Dirty magazine or wearplate
1.
Driver channel worn
2.
Driver is broken/worn
3.
Bent Fasteners
pleaSe read tHe FolloWing CareFUllY
SolUtion
1.
Tighten and recheck
2.
Replace Bumper
1.
Lubricate
2.
Check air supply equipment
3.
Clean exhaust channel
1.
Replace Spring
2.
Use correct size
3.
Clean magazine and nose
1.
Replace wear plate
2.
Replace driver
3.
Use straight Fasteners
Page 8
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
