Set Up Ice Maker; Install Air Filter (On Some Models) - Jenn-Air EDR3RXD1B Use & Care Manual

GETTING STARTED

SET UP ICE MAKER

Please read before using the water system.
IMPORTANT: Prepare the water filter for use
before using the ice. After connecting the
refrigerator to a water source or after replacing
the water filter, fill and discard two full
containers of ice.
1.
To turn on the ice maker, simply lower the
wire shutoff arm. Refer "Ice Maker and
Storage Bin" for further instructions on the
operation of your ice maker.
NOTE: Allow 24 hours to produce the first
batch of ice.
A
A. On/Off control
NOTE: If your model has a base grille filter
system, make sure the base grille filter is
installed so that the Eject button is out. Refer
"Water Filtration System."
ICE MAKER AND STORAGE BIN
IMPORTANT: After connecting the refrigerator
to a water source or replacing the water filter,
fill and discard two full containers of ice to
prepare the water filter for use, before using
the ice.
TURN THE ICE MAKER ON/OFF
1.
To turn on the ice maker, simply lower the
wire shutoff arm.
NOTE: Your ice maker has an automatic
shutoff. As ice is made, the ice cubes will fill
the ice storage bin and the ice cubes will
raise the wire shutoff arm to the OFF (arm
up) position. Do not force the wire shutoff
arm up or down.
2.
To manually turn off the ice maker, lift the
wire shutoff arm to the OFF (arm up)
position and listen for the click.
A
A. On/Off control
INSTALL AIR FILTER
(ON SOME MODELS)
An air filter is 15 times more powerful than
baking soda at reducing common food odors
inside the refrigerator.
On some models, your refrigerator's accessory
packet includes an air filter, which must be
installed prior to use.
INSTALLING THE AIR FILTER
Install the air filter in the ceiling, along the back
wall, of the refrigerator compartment.
1.
Remove the air filter from its packaging.
2.
Snap the filter into place.
GETTING STARTED | 11