Advertisement
Nozzle adjustments
•
In most cases, the same orientation of both nozzles is suitable for every pool shape.
•
A curved and direct track alternate if one of the nozzles is set to 30° and the other to 60°; this
will permit that a very large portion of the floor be covered, and it will help to release any cable
twists.
Distance adjustment
•
On the control panel, select a suitable pool distance according to the pool width.
•
It is recommended to select a larger distance if the nozzle is set to a low speed or if your pool
is sloped. With a pool of 6 m of width, it is recommended to select an 8 m or 10 m distance if
the robot is to run slowly.
Sloped pool adjustments
Set the nozzle to a high speed, so that the robot can cope with the slope, by reinforcing the water flow
rate of the robot (see fig. concerning high speed).
Note!
With some pool shapes, it cannot be guaranteed that the cleaning robot can cover the entire
surface of the floor. You can adapt the nozzle orientation to reduce the moving curve ; however, that
means that the cable will be twist more often.
Recommended nozzle orientation
Direction of higher speed
Pool distance
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Figures
Item 63229
Page 9
09 2021-1
Advertisement
