Advertisement
Troubleshooting
Problem
Cable twists itself or
coils up
Robot does not cover
the entire surface of the
floor
Cleaning robot does not
run
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Possible cause
1. Cable not completely unwound
2. Bad nozzle angle
3. Obstacle in the pool
4. Stuck to the main drain of the pool
5. Long operational time
1. Power-supply unit incorrectly placed
2. Nozzle badly oriented
3. Unusual pool shape
4. Filter system and pump switched on
5. Cable too short
Bad connection of mains cable/plug.
Item 63229
Solution
1. Unplug the plug and disentan-
gle cable.
2. Set water outlet to correct an-
gle.
3. Remove obstacle.
4. Switch off filter system of the
pool.
5. Disentangle cable by hand.
1. Correctly place the power-sup-
ply unit so that the robot is able to
reach every spot.
2. Set nozzle to correct orienta-
tion.
3. Set nozzle so that the moving
radius increases.
4. Switch off filter system of the
pool.
5. Unwind cable further.
Correctly plug in mains ca-
ble/plug.
Page 15
09 2021-1
Advertisement
