CDA HVG95 Manual For Installation, Use And Maintenance page 17

MODELS WITH TRIPLE RING BURNER -
CORRECT POSITIONING OF THE TRIPLE RING BURNER
The triple ring burner must be correctly
positioned (see fig. 14); the burner ribs
must be fitted in their housing as
shown by the arrow.
The burner correctly positioned must
not rotate (fig. 15).
Then position the cap "A" and the ring
"B" (figs. 15 - 16). They shall be level.
✓
The pan support shall be correctly
positioned as indicated in fig. 17.
The pan support shall be level and
must not rotate.
Be sure not to fit the auxiliary, semi-
rapid or rapid burner pan support on
the triple-ring burner. The auxiliary,
semirapid or rapid burner pan sup-
port IS ONLY to be used on the auxil-
iary, semirapid or rapid burners.
Figure 14
Figure 15
Ignitor "S"
Flame
failure
probe "T"
A
B
Figure 16
Figure 17
17