Adjusting The Loudspeaker Volume - Gigaset 5040 Manual

Mute
You can deactivate the telephone's handset and
microphone. Then the other party can no longer hear
you.
J
During a call: Press the Mute key
Activate again: Press the key again.
Activating/deactivating the mute melody
You can activate and deactivate the mute melody for the
mute (default setting: on).
º19#
Hold down the Set key. Initiate function.
Press the Hash key.
0 1
/ 0: deactivate; 1: activate.
º
Hold down the Set key.

Adjusting the loudspeaker volume

While in handsfree mode, you can set the volume to one
of 7 levels and save it (default setting: 1).
H I
... Adjust the volume with the Loud/Quiet key.
Activating/deactivating the telephone lock
The telephone can be locked so that it cannot dial any
phone numbers (with the exception of a baby call
phone number if set). You can continue to receive
incoming calls.
#
Hold down the Telephone lock key.
Press it again to unlock the telephone.
When the telephone is locked, you will see the
bol in the display.
7
en
Baby call (direct call) number setting
If a phone number is set for the Baby Call function, it is
dialled automatically only when the telephone is
locked after you lift the handset (or press the Loud-
#
speaker key) and press any key (except holding down
). The telephone does not allow other phone num-
bers to be dialled, but incoming calls can be received.
º8
o
º
When the Baby Call function is activated and the tele-
phone is locked, you will see the
the display.
Deactivating
Baby Call is deactivated when you deactivate the tele-
phone lock.
Deleting a baby call phone number
º1252
º
Activate/deactivate call duration display
The telephone can display the approximate call dura-
tion in the display (up to 99 min. 59 sec., default setting:
{
on). If the call duration display is activated, the time dis-
play begins 8 seconds after the last digit is dialled.
sym-
º18#
0 1
/
º
Hold down the Set key. Initiate function.
Enter direct call number (max. 32 digits).
Hold down the Set key.
ƒ
and
Hold down the Set key. Initiate function.
Hold down the Set key.
Hold down the Set key. Initiate function.
Press the Hash key.
0: deactivate; 1: activate.
Hold down the Set key.
{
symbols in