Related Manuals for ICT PRX-TSEC
Summary of Contents for ICT PRX-TSEC
- Page 1 PRX-TSEC Range tSec Multi-Technology Card Reader with Bluetooth® Wireless Technology Installation Manual...
- Page 2 Copyright © Integrated Control Technology Limited 2003-2021. All rights reserved. Last Published: 25-May-21 4:56 PM PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual...
-
Page 3: Table Of Contents
Technical Diagram - tSec Extra Reader Technical Diagram - tSec Mini Reader Technical Diagram - Comparison Technical Specifications New Zealand and Australia European Standards UL and ULC Installation Requirements PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... - Page 4 CAN/ULC-S319 UL 294 FCC Compliance Statements Industry Canada Statement Disclaimer and Warranty PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual...
-
Page 5: Introduction
Fully encapsulated design with environmental IP rating of IP65 for outdoor and indoor operation ⦁ Programmable via programming cards ⦁ Keypad output on Wiegand data lines (keypad versions only) PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 6: Tsec Reader Editions
* Keypad editions with vandal resistant cover included. Covers may be purchased separately for readers without keypads, but regular keypad editions do not support vandal resistant covers. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... - Page 7 * Keypad editions with vandal resistant cover included. Covers may be purchased separately for readers without keypads, but regular keypad editions do not support vandal resistant covers. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual...
- Page 8 * Keypad editions with vandal resistant cover included. Covers may be purchased separately for readers without keypads, but regular keypad editions do not support vandal resistant covers. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual...
-
Page 9: Mifare Technology
High security and fraud protection MIFARE/DESFire Products The MIFARE/DESFire products can be expanded to accommodate large numbers of modules using the encrypted RS-485 Network. ICT provides a number of reader and tag/card options in the MIFARE/DESFire range. Cards MIFARE 1K (S50) Proximity Clamshell Card ⦁... -
Page 10: About Mifare Desfire Ev2
Open DES/3DES crypto algorithm in hardware ⦁ Open AES 128 bits crypto algorithm in hardware ⦁ Fully interoperable with existing NFC reader infrastructure ⦁ Operating distance up to 100 mm ⦁ PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 11: Installation Requirements
The National Electrical Code, ANSI/NFPA 70 ⦁ The Canadian Electrical Code, Part I, CSA C22.1 ⦁ AS/NZS 2201.1 Intruder Alarm Systems ⦁ The Local Authority Having Jurisdiction (AHJ) ⦁ PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 12: Mounting
To complete the installation, use the M3 x 8mm Plastite screw provided with the tSec Reader to secure and fasten the top case to the bottom mounted case. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 13: Reader Connection
⦁ Warning: The reader outputs D0 (green wire) and D1 (white wire) can switch to a maximum capacity of 50mA. Exceeding this amount will damage the output. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 14: Wiegand Reader Connection
Do not connect the shield wires together at the reader cable splice. With the shield wire already terminated at the reader, terminate the shield at the controller. Compatible access control card reader communication formats are: 26-, 34-, and 37-bit Wiegand. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 15: Wiegand Reader Connection (Entry / Exit)
Do not connect the shield to any shield used for isolated communication. ⦁ The shield connection must only be connected at one end of the cable in the metallic enclosure (frame ⦁ grounded). PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 16: Rs-485 Reader Locations
Shielded Cable GREEN WHITE ORANGE BROWN Shield not connected BLUE YELLOW VIOLET EXIT D1/ D0/ NB NA The exit reader has the green and orange wires connected together. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 17: Osdp Reader Connection
A correctly encoded MIFARE config card ⦁ A suitably configured MIFARE config card can be ordered from the ICT customer services team. To program the reader using the Config App select the Uart Configuration TLV and set the Baud to 9600. For detailed information on programming tSec Readers, refer to AN-283: Programming tSec Reader Functions. -
Page 18: Programming The Card Reader
When programming is successful, the reader will beep 5 times quickly then restart. Config App Programming Examples The following examples illustrate programming some common tSec Reader configuration requirements, using the Config App. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... - Page 19 Add a new Reader Configuration called Dual LED Mode. Tap the Add TLV dropdown and select the LED Mode option. Set the LED Mode to Dual, then tap Save. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual...
- Page 20 Enable CSN Reading Mode By default, tSec Readers will read ICT secured formats from high frequency cards. However, for lower security sites using third-party cards it can be useful to read and send the Card Serial Number (CSN) instead.
-
Page 21: Mifare Config Card
When programming is successful, the reader will beep 5 times quickly then restart. ICT Encoder Client The ICT Encoder Client is a software application that allows users to encode credentials for use with their ICT tSec Readers, Protege access control system, and optionally other third-party systems. - Page 22 For detailed information on programming config cards using the Encoder Client, including the available configuration settings, refer to the ICT Encoder Client User Guide. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual...
- Page 23 You can now apply the configuration to the required reader(s). Power cycle the reader, and within two minutes place and hold the Wiegand Output Mode config card close to the reader. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual...
- Page 24 Enable CSN Reading Mode By default, tSec Readers will read ICT secured formats from high frequency cards. However, for lower security sites using third-party cards it can be useful to read and send the Card Serial Number (CSN) instead. WARNING: The CSN of your MIFARE card can be read and duplicated by anyone with access to the card. It is not recommended to use CSN reading on high security sites.
-
Page 25: 125Khz Programming Card
The tSec Reader must have the capability to read 125KHz cards Using a 125kHz programming card to program a tSec Reader requires a suitably configured 125kHz programming card. These can be ordered from the ICT customer services team (Ordering code: PRX-PROG-LF). Programming Summary To program a tSec Reader using a 125kHz programming card: You will first need to power cycle the reader you want to program. -
Page 26: Technical Diagram - Tsec Standard Reader
Standard Reader. All measurements are shown in millimeters. ø 4.5mm Screw Hole ø 4.5mm Screw Hole ø 10mm Cable Hole ø 4.5mm Screw Hole ø 4.5mm Screw Hole 23.00 23.00 46.00 PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 27: Technical Diagram - Tsec Extra Reader
Extra Reader. All measurements are shown in millimeters. ø 4.5mm Screw Hole ø 4.5mm Screw Hole ø 10mm Cable Hole ø 4.5mm Screw Hole ø 4.5mm Screw Hole 37.50 37.50 75.00 PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 28: Technical Diagram - Tsec Mini Reader
The dimensions shown below outline the essential details needed to help ensure the correct installation of the tSec Mini Reader. All measurements are shown in millimeters. ø 4.5mm Screw Hole ø 10mm Cable Hole ø 4.5mm Screw Hole 23.00 23.00 46.00 PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 29: Technical Diagram - Comparison
The dimensions shown below provide a direct comparison of the dimensions of the tSec Reader models. 4.5mm Screw Hole 4.5mm Screw Hole 10mm Cable Hole 10mm Cable Hole 4.5mm Screw Hole 4.5mm Screw Hole 46mm / 1.81” 75mm / 2.95” PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 30: Technical Specifications
Credential is AES-256 (NIST certified AES algorithm) credential transmission Reader App Version: 1.04.175 and above technology Credentials can be distinguished by unique site code and card number PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... - Page 31 Integrated Control Technology continually strives to increase the performance of its products. As a result these specifications may change without notice. We recommend consulting our website (www.ict.co) for the latest documentation and product information. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual...
-
Page 32: New Zealand And Australia
New Zealand and Australia Intentional Transmitter Product Statement The R-NZ compliance label indicates that the supplier of the device asserts that it complies with all applicable standards. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 33: European Standards
SP6 (LAN – Ethernet) and DP1 (LAN – Ethernet + PSTN) Tests EMC (operational) according to EN 55032:2015 Radiated disturbance EN 55032:2015 Power frequency Magnetic field immunity tests (EN 61000-4-8) PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... -
Page 34: Ul And Ulc Installation Requirements
Level IV when wired with RS485 Level I when wired with Wiegand tSec Extra Reader Level I Level IV Level I Level IV when wired with RS485 PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual... - Page 35 NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual...
- Page 36 This class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. CAN ICES-3 (A)/NMB-3(A) PRX-TSEC Range | tSec Multi-Technology Card Reader with Bluetooth® Technology | Installation Manual...
- Page 37 Integrated Control Technology Ltd nor its employees shall be liable under any circumstances to any party in respect of decisions or actions they may make as a result of using this information. In accordance with the ICT policy of enhanced development, design and specifications are subject to change without notice.
- Page 38 Disclaimer: Whilst every effort has been made to ensure accuracy in the representation of this product, neither Integrated Control Technology Ltd nor its employees shall be liable under any circumstances to any party in respect of decisions or actions they may make as a result of using this information. In accordance with the ICT policy of enhanced development, design and specifications are subject to change without notice.
Need help?
Do you have a question about the PRX-TSEC and is the answer not in the manual?
Questions and answers