Advertisement
power supply cord.
- The load impedance of any speaker used with this unit must be 4
.
- Be sure to connect the cable from the right speaker to the right
terminal and the cable from the left speaker to the left terminal.
1. Strip off the outer covering, and twist the center conductor. Make
sure the bare ends of the wires are not unravelled. (If they are,
twist them tight again.)
2. Insert the wire to the rear panel of the unit and close the lever.
Notes :
- To prevent damage to circuitry, never short-circuit positive (+) and
negative (-) speaker wires.
- Be sure to connect only positive (white) wires to positive (+)
terminals and negative (blue) wires to negative (-) terminals.
Incorrect connection can damage the speakers.
Positioning the speakers
How you set up your speakers can affect the bass and the sound field.
Note the following points:
- Place the speakers on flat secure bases.
- Placing speakers too close to floors, walls, and corners can result
in excessive bass. Cover walls and windows with a thick curtains.
- Left and right speakers are interchangeable, but front and
surround speakers are not.
Setup example
Place the front, center and surround speakers at approximately the same distance from the
Advertisement
