Kicker KXM Series Owner's Manual
  1. Manuals
  2. Brands
  3. Kicker Manuals
  4. Amplifier
  5. KXM Series
  6. Owner's manual
Kicker KXM Series Owner's Manual

Kicker KXM Series Owner's Manual

Hide thumbs Also See for KXM Series:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

KXM
AMPLIFIERS
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KXM Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Kicker KXM Series

Summary of Contents for Kicker KXM Series

  • Page 1 AMPLIFIERS Owner’s Manual...
  • Page 2 A high-level signal can be run from the source unit’s speaker outputs to the stereo RCA input on the end panel of the amplifi er using the KICKER KISL as shown. Alternatively, the signal can be delivered to the amplifi er using the low-level RCA outputs on the source unit. Keep the audio signal cable away from factory wiring harnesses and other power wiring.
  • Page 3 KICKER KISL (optional) to amplifi er core conductor source unit high-level speaker outputs – to amplifi er shield from source unit high- level speaker outputs Install a fuse within 7” (18cm) of the battery and in-line with the power cable connected to your amplifi er.
  • Page 4 The new extended warranty applies only to KICKER amplifi ers and accessories sold to consumers by Authorized KICKER Dealers in the United States of America or its possessions. It also only applies to the original purchaser of KICKER amplifi ers and accessories.
  • Page 5 FOUR CHANNEL OPERATION minimum impedance of 2 ohm RADIO DETECT BRIDGED OPERATION (MONO) minimum impedance of 4 ohms RADIO DETECT STEREO-AND-MONO-SIMULTANEOUSLY (SAMS) OPERATION minimum impedance of 4 ohms bridged (mono) and 2 ohm per channel stereo RADIO DETECT...
  • Page 6 OPERATION Mini-USB for internal use only; do NOT remove or tamper. KICKER is not responsible for any damage to equipment resulting from connections made to this port. OFF/HP/LP/BP 1X/10X LO PASS RANGE GAIN HI-PASS LO-PASS KICK EQ KXMA400.2 GAIN X-OVER...
  • Page 7 In any audio system, the goal is to reach maximum input and output levels without distortion or clipping. The engineers at KICKER have taken the guesswork, and hassle, out of matching the output voltage of your source unit to the amplifi er with the Gain Matching feature.
  • Page 8 There is a Protection (PRT) LED on the side panel of your Kicker KXM series amplifi er. Depending on the state of the amplifi er and the vehicle’s charging system, the LED will either glow red or be off.

This manual is also suitable for:

Kxma400.2Kxma1200.2Kxma400.4

Table of Contents