Toe-Kick; Water Filter; Water Filter Indication / Reset Filter; Changing The Water Filter - Thermador T24UC925DS Use & Care Manual

Toe-Kick

The Toe-Kick itself can be removed for service or
cleaning (see "Cleaning behind the Toe-Kick" on
page 14).
1. Remove the water
counterclockwise (1/4 turn) the water filter cap and
then pulling the filter out.
2. Remove the stainless
unscrewing and removing the two front screws with a
Philips screwdriver.
3. You can remove the Toe-Kick by simply pulling it
out.
4. To reattach the Toe-Kick, align the holes with the
support tab and screw the frontal screws in the same
position with a Philips screwdriver.
5. Return the water filter and turn clockwise until it
inserts completely into the Toe-Kick. Continue
turning clockwise (1/4 turn) until it locks into place.
NOTE: Removal of
encouraged, but if necessary, it is recommended
to be done by an authorized service personnel.
Page | 12
filter by turning
steel Toe-Kick by
the kickplate is not

Water filter

WARNING:
Connect to potable water supply only. Do not use the
appliance in places where the water quality is poor and
without proper water treatment.
A replacement filter cartridge for filtering particles can be purchased
from our website or any of our qualified dealers. Filter model:
UCTRFLTR10
CAUTION:
After installing a new filter, or after a prolonged period of
disuse, always discard the first 2 complete batches of ice (2
full buckets).
•
If the appliance or the ice has not been used actively for
several weeks or months or if the ice cubes have an
unpleasant taste or odor, change the water filter.
•
The filter must be changed at least every 6 months.
Water Filter Indicator / Reset Filter
The filter should be replaced at least every 6 months.

Changing the Water Filter

The water filter is located on the right side of the base of the unit
(toe-kick). You do not have to remove the toe-kick in order to
change the water filter.
1. Locate the round water filter cap,
and turn it counterclockwise until
it stops (1/4 turn). The water flow
will automatically stop.
2. Pull out the filter from the toe-kick, and slide off the cap.
NOTE: There will be water in the filter. Some spilling may occur.
IMPORTANT: Do not discard the cap. It is part of your refrigerator.
Keep the cap to use with the replacement filter.
3. Take the new water filter out of its packaging and if supplied,
remove the plastic cover from the tip of the nozzle.
4. Slide on the filter cap, and insert the filter into the toekick.
5. Push the filter with the cap, and simultaneously rotate the cap
clockwise until the filter inserts completely into the toekick.
6. Once fully inserted, continue rotating the cap clockwise ¼
turn, so that it locks into place.
7. Discard the used filter.
8. Reactivate the ICE machine, by pressing the ICE button
located on the control panel.