Table of Contents
Advertisement
Wall Mounting with the 7625-3dB Gain and the 7720ANT Adapter.
Remote Antenna Mounting
NOTES:
For detailed instructions on installing the above antenna kits, please read the enclosed
Installation Instructions.
1. Mount the 7720PLUS Subscriber
Radio.
2. Replace the radio's cover.
3. Remove the plastic insert from the
cover by rotating it 45° counter-
clockwise.
4. Replace with the insert provided
with the antenna kit.
5. Mount
the
7720ANT
pointing either up or down, not to
the side.
6. Mount the 7625-3DB Gain directly
on to the 7720ANT.
7. Mount the plastic bracket (supplied)
to the wall 3 inches from the top of
the antenna.
1. Mount the 7720PLUS Subscriber Radio.
2. Replace the radio's cover.
3. Mount the 7720ANT directly on to the 7720PLUS radio.
4. Mount antenna outdoors in the location determined earlier in this section.
5. Mount the ADEMCO antenna cables.
1. Use only ADEMCO Cables P/N 7626-5 (5'), 7626-12 (12'), 7626-25HC (25') or
7626-50HC (50').
2. Do not attempt to make the antenna cables yourself, and do not under any
condition try to splice them!
Powering Up
After all wiring is complete and the unit is mounted, plug the
battery cable of the 7720PLUS into the connector next to the
terminal block.
Apply power to the radio.
The LEDs will flash consecutively for a brief time to allow entry
into programming mode. If the 7720PLUS has been programmed,
the LEDs will begin to flash according to their functions. If the
7720PLUS has not been programmed, the LEDs will flash in
unison indefinitely.
vertically
– 27 –
Advertisement
Table of Contents
