Table of Contents
Advertisement
ANTENNA MOUNTING OPTIONS
Outdoor Antenna Mounting
The 7720PLUS must always be mounted indoors. If the only suitable antenna location found is
outside of the protected building, mount the 7720PLUS close to this location on the inside of the
building and connect an external (outdoor) antenna to the radio. Carefully follow all instructions
included in these optional parts to insure integrity of the weather-proof seals on all outside
connections. The following antenna kits can be utilized for remote or outdoor mounting.
Standard Wire Antenna Mounting (omnidirectional)
Wall Mounting using the 7825DP (strongest signal is perpendicular
Antenna
Description
7720 ANT
Adapter for the Remote Antenna
7625-3dB
3dB Gain Antenna
7825
Outdoor Antenna with bracket
7670F
Remote Antenna bracket
7674
6dB Gain Direct
Indoor Antenna Mounting
If the location found allows indoor mounting of the antenna, then the antenna
selected depends on the mounting surface of the 7720PLUS. If it is possible to
mount the 7720PLUS on a ceiling or on an attic joist, you can use the included
wire antenna, which provides excellent performance (see Standard Wire
Antenna Mounting). If the only mounting surface available is a wall, you can
use the 7825DP (see Wall Mounting).
1. Mount the 7720PLUS Subscriber
Radio on the ceiling or on an attic
joist.
2. Replace the 7720PLUS cover.
3. Push the antenna into the antenna
receptacle until it bottoms out.
4. The antenna should be vertical and
straight.
5. Rotate the antenna until it snaps into the
locked position. DO NOT BEND THE
ANTENNA!
to the wall)
1. Mount the radio to a wall or other
vertical surface.
LEDs are in the upper right hand
corner.
2. Replace radio's cover.
3. Follow the Installation Instructions
included
with
mounting
to
Subscriber Radio.
Make sure the 3
the
7825DP
for
the
7720PLUS
– 26 –
Note
omnidirectional
omnidirectional
directional
Advertisement
Table of Contents
