Setting The Ip Address Of The Site Maintenance Terminal Pc; Connecting The Site Maintenance Terminal Pc To The Bts - Huawei BTS3900 GSM Commissioning Manual

4 Starting the Site Maintenance Terminal System
4.1 Setting the IP Address of the Site Maintenance Terminal
PC
This describes how to set the IP address of the Site Maintenance Terminal PC to the same network
segment as the IP address (192.168.0.72/255.255.255.0) of the BTS.
Prerequisite
The Site Maintenance Terminal PC is configured with the TCP/IP protocol.
Procedure
Step 1 Take the Windows XP operating system as an example. On the Windows XP operating system,
choose Start > Control Panel.
Step 2 Select Network Connections. A dialog box is displayed. Right-click the Local Area
Connection icon.
Step 3 Choose Properties on the shortcut menu,. The Local Area Connection Properties dialog box
is displayed.
Step 4 Select Internet Protocol (TCP/IP).
Step 5 Click Properties. The Internet Protocol (TCP/IP) Properties dialog box is displayed.
Step 6 Select Use the following IP address.
Step 7 Enter the correct IP address, subnet mask, and default gateway. Ensure that the IP address of the
Site Maintenance Terminal PC and the IP address (192.168.0.72/255.255.255.0) of the BTS are
located in the same network segment, so that a local maintenance path can be set up.
Step 8 Click OK to complete the setting.
----End
4.2 Connecting the Site Maintenance Terminal PC to the
BTS
To operate and maintain the BTS on the Site Maintenance Terminal, the Site Maintenance
Terminal PC should be connected to the ETH port on the main control module of the BTS using
the crossover cable.
Prerequisite
The IP address and the subnet mask of the Site Maintenance Terminal PC are set. The IP address
of the Site Maintenance Terminal PC and the IP address (192.168.0.72/255.255.255.0) of the
BTS are on the same network segment.
4-2 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
BTS3900 GSM
Commissioning Guide
Issue 03 (2008-07-15)