Locally Logging In To The Bts - Huawei BTS3900 GSM Commissioning Manual

BTS3900 GSM
Commissioning Guide
Procedure
Step 1 Use the crossover cable to connect the Site Maintenance Terminal PC to the BTS. Connect one
end of the cable to the ETH port on the main control module of the main cabinet, and connect
the other end of the cable to the Ethernet cable port on the Site Maintenance Terminal PC.
Step 2 Open the command window.
l
l
Step 3 Run the ping target_name command to verify the network connection between the PC and the
BTS.
If the information similar to that in the following example is returned, the LMT PC and the
GBAM can communicate normally. In this example, the IP address of the external network is
192.168.0.72.
Pinging 192.168.0.72 with 32 bytes of data: Pinging 192.168.0.72 with 32 bytes of
data: Reply from 192.168.0.72: bytes=32 time=1ms TTL=253 Reply from 192.168.0.72:
bytes=32 time=1ms TTL=253 Reply from 192.168.0.72: bytes=32 time=1ms TTL=253 Reply
from 192.168.0.72: bytes=32 time=1ms TTL=253 Ping statistics for 192.168.0.72:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times
in milli-seconds: Minimum = 1ms, Maximum = 1ms, Average = 1ms
----End

4.3 Locally Logging In to the BTS

You can run the Site Maintenance Terminal to directly log in to the BTS.
Prerequisite
l
l
Procedure
Step 1 Double-click btsm.exe to start the Site Maintenance Terminal System.
l
l
Issue 03 (2008-07-15)
If the operating system of the Site Maintenance Terminal PC is Windows 98, choose Start
> Program > MS-DOS Prompt. The command window is displayed.
If the operating system of the Site Maintenance Terminal PC is Windows 2000/XP, choose
Start > Run. In the Run dialog box, run the cmd command. The command window is
displayed.
NOTE
target_name indicates the IP address of the BTS.
The Site Maintenance Terminal PC is connected properly to the BTS.
The Site Maintenance Terminal PC is installed with the latest site maintenance terminal
software.
If the communication between the Site Maintenance Terminal PC and the BTS is not set
up, the Communication failed dialog box is displayed, as shown in
Step 2.
If the communication between the Site Maintenance Terminal PC and the BTS is set up, a
window is displayed, as shown in
successfully started.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
4 Starting the Site Maintenance Terminal System
Figure 4-2. The Local Maintenance Terminal is
Figure 4-1. Go to
4-3