Practical Operating Advice; Before First Use; Load Limits; Using The Supports (Runners, Modules And Trolleys) - ELRO PRECIJET+ Operating Manual

Gas & electric combi ovens

Hide thumbs

Table Of Contents

Table of Contents

3.1 BEFORE FIRST USE

After manufacture units are tested and their accessories and instruction manuals put inside the oven cavity.

A thorough clean should be undertaken before use.

Using domestic washing up liquid and hot water will give good results, rinse thoroughly and dry.

3.2 LOAD LIMITS

Attention: For your safety and that of the equipment always comply with these load limits.

Model

6 level GN 1/1

10 level GN 1/1

10 level GN 2/1

6+6 level GN 1/1

6+10 level GN 1/1

20 level GN 1/1

20 level GN 2/1

3.3 USING THE SUPPORTS (Runners, modules and trolleys)

3.3.1 SUSPENDED RUNNERS

On 6 and 10 level ovens

To remove the suspended runners from each side of the oven cavity:

- Lift gently by the middle.

- Then lift off the front and back pegs

- Swing the runners towards the middle of the oven and remove them.

Attention: if a core probe kit is fitted remove this before removing the right hand

runners

To refit reverse the above instructions

3.3.2 RUNNER OR BANQUETING TROLLEYS

On 10 level ovens

Remove the suspended runners as explained in the paragraph « Suspended

runners ».

- Locate the rolling frame in the base of the oven

Attention: the oven must be at the exact same height as the trolley table.

- Move the table transporting the runner module or banqueting frame so it is

in front of the oven.( Always ensure the module is securely locked in place

during transport)

- Position the trolley in front of the oven and release the catch

- Push the module onto the rolling frame.

To remove it reverse these instructions

Page 8