Leupold GX-3c Operating Instructions Manual page 25

INPUT THE TEMPERATURE AND ALTITUDE AT WHICH THE
CLUB SELECTOR SETUP WAS MEASURED.
Once the striking distances have been input, press MODE and
follow these steps:
1) The last saved temperature will be flashing
in the bottom portion of the display . If you
wish to input a temperature other than the
one shown, proceed to step 2 . To save the
shown temperature, press MODE and skip
to step 3 below .
2) Press POWER to begin incrementing through the temperature
settings . The default setting is 75 degrees F (25 degrees
C) . Pressing POWER will increment through a range of 30
degrees to 120 degrees F (0 degrees to 50 degress C) . When
the appropriate temperture is displayed, press MODE to save
your selection and move on to the altitude input .
3) The last saved altitude will be flashing in the bottom portion
of the display . If you wish to input an altitude other than the
one shown, proceed to step 4 . To save the shown altitude
and return to ranging mode, let the unit sit idle for at least
30 seconds until an automatic power-down occurs, or simply
press and hold MODE for at least 2 seconds . To continue
through the Quick Set Menu and manipulate another
22