Adding Or Replacing Add-In Cards - Gateway 710XL User Manual

Chapter 11: Upgrading Your Computer

Adding or replacing add-in cards

An add-in card is a card used in the computer to add functionality to the system.
Use the following instructions to replace, add, or reseat an add-in card.
To replace, add, or reseat an add-in card:
1
Remove the side panel by following the instructions in
panel" on page
2
For more stability, place your computer on its side. To avoid scratching
the case, place it on a towel or other non-abrasive surface.
3
If you are replacing a card, disconnect any cables that are attached to the
card, noting their locations and orientation. (You will reconnect the cables
after you install the new card.) See the add-in card documentation for
further instructions.
4
If you are replacing a card, remove the retention screw that secures the
card to the case.
- OR -
If you are adding a card, remove the retention screw from a blank slot.
206
192.
www.gateway.com
"Removing the side