Table of Contents
Advertisement
4. Select the "Send Database to GPS Unit" option on the PC.
5. In the SL60, press SYS. Turn the Large knob to Waypoint
6. Send the database to the Apollo. Follow the directions
7. The PC will read the database, wait for the Apollo to erase
8. You can now exit from Waypoint Manager.
Update
Apollo GPS
Application
Software
!
Apollo 360
1. Press the GOTO and INFO buttons at the same time
2. Press ENT on the 360 to proceed with the download.
3. Make sure the serial cable connects the 360 to the PC.
4. Start Waypoint Manager.
5. In the File menu item, click on Application, and then select
6. Send the software to the 360.
Database. Turn the Small knob to the Database Update
page. Press ENT to enable updating. No controls may be
used until the update is complete.
shown on the Apollo screen.
the old database, then send the new database. After the
data has been sent, the PC is finished, but the Apollo must
still verify the new database. The Apollo will display
"PASS" or "FAIL". If the message is "pass," continue. If
the message is "fail," try again. If the procedure continues
to "fail," call technical support.
Summaries of the application software update operation
for your specific Apollo GPS are described below for
selected products. You must install the application software
onto your hard drive first (see page 14).
(Not For Databases!)
If you are not sure about this procedure, call technical
support before loading application software.
while you power on the 360.
the "Send Application to GPS Unit" options on the PC.
CAUTION
Advertisement
Table of Contents
