Advertisement
EEI–2933
CHAIR
Thank you for purchasing the MODWAY CHAIR!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
Component:
7
3
Customer Service 908-368-1025 www.modwayfurniture.com
5
1
4
2
︱
Hardware:
A
B
6
Bolt M8x40mm
x 8
Allen Wrench M5
x 1
1. Chair Back
x2
2. Chair Seat
x1
3. Left Frame
x1
4. Right Frame
x1
5. Back Cushion
x1
6. Seat Cushion
x1
7. Batyline
x1
Page 1 of 3
Advertisement
Table of Contents
Related Manuals for modway EEI-2933
Summary of Contents for modway EEI-2933
- Page 1 EEI–2933 CHAIR Thank you for purchasing the MODWAY CHAIR! Before you start, here are some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 EEI–2933 CHAIR STEP 1: Please put Left Frame (3) on a carpeted or padded area. Insert the tenon on Chair Seat (2) into the rabbet on Left Frame (3) at first. Insert Wooden Bar or Chair Back (1) one by one through the drilling hole. STEP 2: Please insert Batyline fabric (7).
- Page 3 EEI–2933 CHAIR STEP 3: Carefully turn over the assembled Chair Back (1), Chair Seat (2), Left Frame (3) and Right Frame (4). Insert 2 pieces of Bolt (A) into the pre-drilled holes on Chair Back (1) through the top pre-drilled holes on Left Frame (3).
Need help?
Do you have a question about the EEI-2933 and is the answer not in the manual?
Questions and answers