Serial Control Interface; Operation - Sanyo PDG-DWL100 Owner's Manual

Hide thumbs Also See for PDG-DWL100:

Table of Contents

Appendices

Serial Control Interface

1. Connect a RS-232C serial cross cable to SERVICE PORT on the

2. Launch a communication software provided with PC and setup the

3. Type the command for controlling the projector and then enter the

• The default of the baud rate is set to 9600 bps.

• Enter with ASCII 64-byte capital characters and one-byte characters.

English

All manuals and user guides at all-guides.com

This projector provides a function to control and monitor the

projector's operations by using the RS-232C serial port.

projector and serial port on the PC.

communication condition as follows:

"Enter" key.

Example

When you want to change the input to Computer 2, Type 'C' '0' '6'

'Enter'.

Baud rate

: 9600 bps

Parity check:

: none

Stop bit

: 1

Flow control

: none

Data bit

: 8

Table of Contents