Usage Notice; Precautions - Sanyo PDG-DWL100 Owner's Manual

Usage Notice

Precautions

Follow all warnings, precautions and maintenance as recom-
mended in this user's guide to maximize the life of your unit.
■
■
■
■
■
■
■
■
■
■
■
2
English
All manuals and user guides at all-guides.com
This apparatus must be earthed.
Warning-
Do not look into the projector's lens when the
Warning-
lamp is on. The bright light may hurt your eyes.
To reduce the risk of fire or electric shock, do not
Warning-
expose this projector to rain or moisture.
Please do not open or disassemble the projector
Warning-
as this may cause electric shock.
When replacing the lamp, please allow unit to
Warning-
cool down, and follow all replacement instruc-
tions..
This projector will detect the life of the lamp
Warning-
itself. Please be sure to change the lamp when it
shows warning messages.
Reset the "Lamp Counter Reset" function from
Warning-
the on-screen display "Setting" menu after re-
placing the lamp module (refer to page 29).
When switching the projector off, please ensure
Warning-
the cooling cycle has been completed before
disconnecting power. Allow 120 seconds for the
projector to cool down.
Do not use lens cap when projector is powered
Warning-
on.
Turn on the projector first and then the signal
Warning-
sources.
When the lamp reaches the end of its life, it will
Warning-
burn out and may make a loud popping sound.
If this happens, the projector will not turn back
on until the lamp module has been replaced. To
replace the lamp, follow the procedures listed
under "Replacing the Lamp".