Replacing The Lamp - Sanyo PDG-DWL100 Owner's Manual

Appendices

Replacing the lamp

The projector will detect the lamp life itself. It will show you a
warning message
Warning: To avoid
When you see this message, change the lamp as soon as pos-
burns, allow the
sible. Make sure the projector has been cooled down for at
projector to cool for
at least 45 minutes
least 45 minutes before changing the lamp.
before you replace the
lamp!
Warning: To reduce the
risk of personal injury,
do not drop the lamp
module or touch the 5. Push up and remove the cover.
lamp bulb. The bulb
may shatter and cause
injury if it is dropped.
Warning: For contin-
ued safety replace with
a lamp of the same
type.
46
English
All manuals and user guides at all-guides.com
1
2
3
4
Lamp Replacing Procedure:
1. Switch off the power of the projector by pressing the "ON/
STAND-BY".
2. Allow the projector to cool down at least 45 minutes.
3. Disconnect the power cable.
4. Use a screwdriver to remove the 2 screws from the cover. 
6. Remove the 2 screws from the lamp module  and pull up
the lamp bar. 
7. Pull out the lamp module by force. 
8. Install the new lamp module by reversing the previous steps.
9. After replacing the lamp, turn on the power, and select the
menu ->[Setting] ->[Lamp Counter Reset] to reset the lamp
usage hours. See page 29.