Table of Contents
Advertisement
34
C
2: I
HAPTER
NSTALLING THE
S
WITCH
4 Connect the Matrix Cables, as shown in Figure 9:
a Connect a Matrix Cable to the port marked Unit 1 on the Matrix
Module. Connect the other end of this cable to the matrix port of the
Switch that contains the Matrix Module.
b Connect a second Matrix Cable to the port marked Unit 2 on the
Matrix Module. Connect the other end of this cable to the matrix port
of the second Switch.
c Repeat steps a and b for any additional units.
5 If you use the management software of the units:
Ensure that all the units have the same version of management
software
Ensure that you re-configure the stack-wide features on all the units
For more information about management software, see "Managing the
Switch" on page 38.
Figure 9 A stack of multiple units
Advertisement
Table of Contents
