Garmin Mobile 20 Set Up And Go Manual page 6

Mount Your Phone
➌
1. Select the adapter cable that fits your phone.
Additional adapter cables are available at
http://my.garmin.com/shop.
2. Connect the adapter cable to the power connector
on your phone and connect the other end of the
adapter cable into the power connector on the
bottom of the phone mount. This charges your
phone while it is in the mount.
3. Gently pull the slide bars away from the mount.
4. Slide your phone into the mount.
5. Adjust the posts for the best fit.
NOte: Some phones will not charge outside of a
specific temperature range. If your phone does not
charge, refer to the phone's documentation for more
information.
To remove your phone from the mount, disconnect the
cable, turn the phone sideways, and remove the phone.
Plug in the GPS 20SM
➍
Plug the GPS 20SM into an available power receptacle
in your vehicle; the GPS 20SM automatically turns on.

Pair the GPS 20SM
➎
Bluetooth wireless technology establishes a wireless
®
link between your mobile phone and the GPS 20SM.
See www.garmin.com/mobilephones
mobile phone is compatible with the GPS 20SM.
The wireless connection between your phone and the
Bluetooth GPS is created automatically. To use the
hands-free features of the GPS 20SM, you must "pair"
the two devices to establish a wireless connection.
1. Close the Garmin Mobile XT application.
2. Make sure your mobile phone and GPS 20SM are
turned on and within 10 meters of each other.
3. Enable your mobile phone's Bluetooth component.
This might be in a menu called Settings, Bluetooth,
Connections, or Hands-free.
4. Initiate a search for Bluetooth devices.
5. Select the GPS 20SM from the list of devices.
6. Enter the GPS 20SM's Bluetooth PIN (1234) into
your mobile phone.
For more specific instructions on pairing your phone,
refer to your phone's documentation.
to verify that your
Garmin Mobile™ 20 set up and go!