Eaton ET5040 Operator's Manual page 12

Operating instructions
Crimp selections – auto mode continued
Step 5
Figure 18
Screen will prompt you to select "Hose Dash" size, press
down arrow to view options. Make selection by pressing
desired dash size. (See figure 18).
Step 7
Figure 20
Install the defined dies per the load/ unload procedure.
(Page 8) Select the check mark when the correct dies are
securely installed. (See figure 20).
Press Check prompt on bottom of screen to finish selection
process and to display tooling requirements for hose series
selection. (See figure 20).
12 EATON ET5040 Operator´s Manual E-EQCR-TT002-E1 July 2015
Step 6
Figure 19
Next select "Fitting Type" by pressing down arrow to view
options and pressing desired "Fitting Type" . (See figure 19).
!
Note: If hose series or hose dash size is not available in the
selection, please review Eaton PowerSource for compatibility. If crimp
specifications and die part number information is available for hose
series and hose dash size on PowerSource for ET5040, please use
manual mode (page 16) to perform the crimping operation.
Step 8
Figure 21
Once the selection process is complete, the screen will
change to display to current selection menu with relevant
crimping specification displayed.
!
Note: "Current Selection" screen displays selected product, assembly
instructions and appropriate specifications. (See figure 21).