Packing List - Ego Power+ CS1400E Manual

The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
The declared vibration total value may also be used in a
preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used;In order to protect the operator, user should wear
gloves and ear protectors in the actual conditions of use.

PACKING LIST

PART NAME
Chain saw power head
Saw chain
Guide bar
Chain sheath
Operator's manual
DESCRIPTION
KNOW YOUR CHAIN SAW (Fig. A)
1. Trigger Switch
2. Lock-off Button
3. Battery-release Button
4. Oil Tank Cap
5. Oil Inspection Window
6. Saw Chain
7. Guide Bar
8. Latch
9. Ejection Mechanism
10. Electric Contacts
11. Chain Kickback Brake Handle
12. Chain Tensioning Knob
13. Front Handle
14. Rear Handle
15. Chain Tensioning Screw
16. Side Cover
17. Side Cover Knob
18. Chain Sheath
19. Lubricating Hole
20. Sprocket in Guide Bar Tip
56 VOLT LITHIUM-ION CORDLESS CHAIN SAW — CS1400E/CS1600E
NOTICE:
The chain kickback brake handle services as the
lever for chain brake activation. It also provides protection
against projecting branches and helps prevent the left hand
from touching the saw chain if it slips off the front handle.
ASSEMBLY
WARNING:
not operate this product until the parts are replaced. Use of
this product with damaged or missing parts could result in
serious personal injury.
WARNING:
create accessories not recommended for use with this chain
QUANTITY
saw. Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
1
personal injury.
1
WARNING:
1
cause serious personal injury, always remove the battery
pack from the tool when assembling parts.
1
1
ASSEMBLING/REPLACING THE BAR AND CHAIN
WARNING:
bar and chain; these components are sharp and may
contain burrs.
1. Position the chain saw power head on its side with
the side cover facing upwards (Fig. H).
2. Turn the side cover knob counterclockwise to remove
the side cover and then loosen the chain tensioning
knob as much as possible.
3. Lay the new saw chain in a loop on a flat surface and
straighten any kinks (Fig. I).
4. Place the chain drive links into the guide bar groove
and make the chain a loop at the back of the guide
bar (Fig. J).
5. Hold the chain in position on the guide bar and place
the loop around the sprocket of the power head.
6. Slide the guide bar slot over the alignment flanges
until the tension adjusting pin is inserted in the lower
hole in the tail of the bar (Fig. L1).
NOTICE: Small directional arrows are engraved in the
saw chain. Another directional arrow is molded into the
housing. When looping the saw chain onto the sprocket,
make sure that the direction of the arrows on the saw
chain will correspond to the direction of the arrow on the
housing. If they face in opposite directions, turn over the
saw chain and guide bar assembly (Fig. L2).
7. Replace the side cover and slightly tighten the side
cover knob.
If any parts are damaged or missing, do
Do not attempt to modify this product or
To prevent accidental starting that could
Always wear gloves when handling the
EN
11