Garmin GPS 150 Pilot's Manual page 77

NavData and User Data Installation and Operation
®
The NavData card supplied with your GPS 150 can be installed or removed ONLY
when the GPS 150 is turned off.
The User Data card can be used to make a backup of user waypoints, routes,
checklists, proximity alarms, etc. for later reference and use. The UserData card can
also be used to transfer the same information to another GPS 150.
To save the user data to the User Data card:
1. Install the UserData card while the unit is off.
2. Turn the GPS 150 on by rotating
O
3. Rotate to highlight 'Save user data?'.
E
4. Press .
The message 'Saving to card' is displayed while the GPS 150 transfers all user data
to the User Data card. It may take a few minutes to complete the transfer. When all
user data is transferred, the GPS 150 will instruct you to turn the unit off, remove the
user card and insert the Jeppesen NavData card. After this is complete, the GPS 150 is
ready for normal operation.
Appendix A
Insert the card with the thumb tab
at the top, and the beveled corner on
the bottom right.
B
clockwise.
APPENDIX A
NavData & UserData Cards
User Data card transfers.
Message following User Data card transfer.
User Data cards are available from
your local GARMIN dealer.
67