Napoleon PTSS215 Mounting Instructions page 3

Trailer Ball Mounting Instructions:
1. Place the ball mount over the ball on your drawbar or bumper.
2.Tighten the two wing screws until the mount is firmly held in place.
3. Once the mounting arm is tight, the grill can be mounted:
a. Lock the lid of the grill closed with the latch.
b. Hold the grill by the handle with one hand, place the other hand
under the grill in the centre of the front tapered surface.
c. Place the grill bottom on the platform and slide it forward to
engage the tab protruding from the bottom of the grill. Ensure that the
tab is properly engaged.
d. When the dimples on the bottom of the unit line up with the holes on the
platform, the latch is ready to be fastened.
4. Once the grill has been attached, thread the regulator (clockwise) into the regulator
mount. On tube burner version, lift the burner slightly to align it with the orifice. Tighten
by hand.
5. To fasten the regulator locking bracket, locate it at the bottom back corner of the
regulator mount and turn the regulator until the gas inlet is aligned with the hole in the
regulator locking bracket. Slide the locking bracket forward until the two tabs engage into
the slots on the regulator mount. Tap in firmly.
6. Attach the cylinder to the regulator by turning clockwise. (Be sure not to cross thread
the cylinder.)
Post Mounting Instructions:
1. Remove all the parts from the packaging.
2. Attach the post to the casting using four 1/4-20 x 1" hex head bolts. Ensure that
the holes on the back side of the post face the same direction as the groove on the
bottom back of the foot casting.
3. Place the spacers provided on the three nutserts that are closest to the front of the
post.
4. Place the platform with the latch to the front onto the three spacers. Attach with the three
1/4-20 x 1 3/4" flat head bolts. Tighten firmly in place.
5. Attach the back post cover with the two #8 screws provided.
6. Once the post is completely assembled, the grill can be mounted:
a. Lock the lid of the grill closed with the latch.
b. Hold the grill by the handle with one hand, place the other hand under the grill in the centre of the
front tapered surface.
c. Place the grill bottom on the platform and slide it forward to engage the tab protruding from the
bottom of the grill. Ensure that the tab is properly engaged.
d. When the dimples on the bottom of the unit line up with the holes on the platform, the latch is
ready to be fastened.
7. Once the grill has been attached, thread the regulator (clockwise) into the regulator mount. On
tube burner version, lift the burner slightly to align it with the orifice. Tighten by hand.
8. To fasten the regulator locking bracket, locate it at the bottom back corner of the regulator mount
and turn the regulator until the gas inlet is aligned with the hole in the regulator locking bracket.
Slide the locking bracket forward until the two tabs engage into the slots on the regulator
mount. Tap in firmly.
9. Attach the cylinder to the regulator by turning clockwise. (Be sure not to cross
thread the cylinder.)