Download Print this page
Napoleon PTSS215 Mounting Instructions

Napoleon PTSS215 Mounting Instructions

Accessory
Hide thumbs Also See for PTSS215:

Advertisement

Available languages

Available languages

Quick Links

GOURMET GRILLS
LE GRILS DU GOURMET
MANUFACTURED BY / MANUFACTURE PAR
NAPOLEON APPLIANCE CORP.,
214 BAYVIEW DR., BARRIE, ONTARIO, CANADA L4N 4Y8
CUSTOMER SERVICE PHONE: (866) 820-8686 FAX: (705)727-4282
EMAIL: ask@nac.on.ca WEBB SITE: www.napoleongrills.com
PTSS215 ACCESSORY MOUNTING INSTRUCTIONS
Please use this manual in conjuction with your main manual to properly assemble your gas grill. Refer to
the main manual for operating, cleaning, and maintenance instructions.
WARNING:
- This grill is not to be used while the vessel is in motion.
- When operating the grill on a vessel, only 8 oz cylinders that are DOT approved (2P/2Q) can be used in the United States. In
Canada a 16 oz. cylinder may be used. These cylinders are available at your local marina or hardware store.
- This grill is not to be mounted on a railing while the boat is in motion. It is highly recommended that the grill head is removed and
stored away before casting off.
Propane and butane can be more dangerous than gasoline. These gases are heavier than air. If they escape, they collect in the lower
parts of the vessel and are very difficult to remove. Make sure all propane appliances and cylinders are properly secured, protected
and ventilated, so that escaping gas can not reach bilges or other enclosed spaces. The equipment installation should meet Federal
Government standards.
Make sure that all valves are working properly, and that all connections are tight.
When used on a small vessel, this unit must be installed according to the manufacturer's instructions.
This appliance is not to be installed on any small commercial vessel that is carrying passengers.
Do not install or store this appliance in a manner that permits or is likely to permit ingress or trapping of the gas below deck.
This grill is not to be operated within a cabin or any other enclosed area. This grill is to be used outdoors only.
N415-0117 / APR 09/04

Advertisement

loading

Summary of Contents for Napoleon PTSS215

  • Page 1 CUSTOMER SERVICE PHONE: (866) 820-8686 FAX: (705)727-4282 EMAIL: ask@nac.on.ca WEBB SITE: www.napoleongrills.com PTSS215 ACCESSORY MOUNTING INSTRUCTIONS Please use this manual in conjuction with your main manual to properly assemble your gas grill. Refer to the main manual for operating, cleaning, and maintenance instructions.
  • Page 2 Rail Mount Instructions: 1. Place mount “A” on the outside of the railing, with the mounting platform facing up. 2. Attach mount “B” to mount “A” using the four 1/4-20 x 1” bolts. 3. Level the platform and tighten the top two bolts first. Be sure the platform is pinched tight before tightening the bottom two bolts.
  • Page 3 Trailer Ball Mounting Instructions: 1. Place the ball mount over the ball on your drawbar or bumper. 2.Tighten the two wing screws until the mount is firmly held in place. 3. Once the mounting arm is tight, the grill can be mounted: a.
  • Page 4 INSTRUCTIONS POUR LES ENSEMBLES DE SUPPORT AVERTISSEMENT : - Ce gril ne doit pas être utilisé lorsque le bateau est en mouvement. - Lorsque vous utilisez le gril sur un bateau, seules des bonbonnes de 8 oz certifiées DOT (2P/2Q) peuvent être utilisées aux États- Unis.
  • Page 5 Instructions pour le support mural : 1. En vous servant des deux trous qui se trouvent sur le tube vertical, fixez le support mural au mur. 2. Assurez-vous que les dégagements minimums aux matériaux combustibles sont maintenus, 4” (100 mm) des côtés et 6” (150 mm) à...
  • Page 6 Instructions pour le support sur poteau : 1. Sortez toutes les pièces de l’emballage. 2. Fixez le poteau à la base en fonte à l’aide de quatre boulons à tête hexagonale 1/ 4-20 x 1”. Assurez-vous que les trous à l’arrière du poteau soient orientés dans la même direction que les trous à...