Table of Contents
Advertisement
Gas Skillets
Gas Connections
Do not connect the appliance to the electrical supply until after the gas connection has been made.
Never use an open flame to check for gas leaks. Check all connections for leaks using soapy water before use.
The pipe thread compound used when installing pipes must be a type that is resistant to the action of liquified
petroleum or propane gases.
If this equipment is being installed at over 2,000 feet altitude and was not so specified on order, contact service department.
Failure to install with proper orifice sizing may void the warranty.
All gas supply connections and any pipe joint compound used must be resistant to the action of propane gases.
Connect gas supply to the appliance. The gas supply line must be at least equivalent of 3/4" iron pipe with an incoming
pressure of 7" - 14" W.C. (Water Column) for natural gas or 11" - 14" W.C. (Water Column) for propane gas. Make sure the
pipes are clean and free of obstructions, dirt and piping compound.
Codes require that a gas shutoff valve be installed in the gas line ahead of the tilting braising pan.
Natural gas and propane gas skillets are equipped with fixed orifices and no adjustment is necessary. Gas burner
manifold is set at 3.5" W.C. (Water Column) for natural gas, and 10" W.C. (Water Column) for propane gas.
After piping has been checked for leaks, all piping receiving gas should be fully purged to remove air.
Electrical Connection
Do not connect the appliance to the electrical supply until after the gas connection has been made.
This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard
and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the
grounding prong from this plug. (120V units only).
The wiring compartment is located behind the control panel. For units operated on electrical supply other than 120 volts,
remove the wiring compartment cover and make electrical connections per the wiring diagram located inside the control
housing cover panel. The braising pan must be grounded in accordance with requirements of the National Electrical Code
or applicable local code.
Replace wiring compartment cover.
INSTALLATION & OPERATION MANUAL 10094 REV 0 (08/21)
WARNING
WARNING
CAUTION
NOTICE
WARNING
WARNING
ELECTRICAL GROUNDING INSTRUCTIONS
Installation
7
PAGE
OF24
Advertisement
Table of Contents
