Advertisement
RPK4-HD1101
Part One: Removing the factory radio from the vehicle
1.1 - Push the hazard warning switch
button (A
screwdriver into the slot below the button,
and push down on the center clip.
1.3 - If the vehicle is equipped with
manual transmission, the shift knob
(A) will need to be removed. To do
this, lower the shift lever boot (B) to
release the hooks (C) from the knob.
Remove the shift knob by twisting it
counterclockwise.
1.6 - Remove the screws (A), detach
the clips (B) and hook (C) by pulling the
center holder (D) up, and disconnect
the front accessory power socket
connector (E).
P
ifi A
C
ti
1.4 - Using a plastic trim tool, detach
the clips (A, B) by pulling the center
console front panel (C) up. If equipped,
disconnect the seat heater switch
connectors (D).
1.7 - Remove the center pocket (A).To
do this, remove the screws (B).Open
the lid, then pull the pocket toward you
by hand to detach the clips (C). Close
the lid, then remove the pocket.
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
1.2 - Pull the upper panel (A) in the direction shown to
release the remaining clips, disconnect the hazard warning
switch connector (B), and if equipped, sunlight sensor
connector (C) and navigation sub display connector (D).
Detach the harness clips (E), then remove the upper
PAC-audio.com
Complete Radio Replacement Kit with
Integrated Climate Control Retention for
2003-2007 Honda Accord
panel.
1.5 - Using a plastic trim tool, pry up on
the right side of the console pocket (A)
with a trim tool, and detach the clips,
then remove the pocket.
1.8 - Remove the 3 phillips head screws
and 2 8mm bolts holding the radio to
the dash. Pull the radio from the dash
and disconnect the connectors and the
antenna lead, then remove the radio
and set aside.
Rev: V8
Date: 081318
Page 2
Advertisement
