Do you have a question about the C2R-CHY4 and is the answer not in the manual?
Questions and answers
Jack E. Taylor
June 1, 2025
do i have to connect the amp blue/white wire
1 comments:
Mr. Anderson
June 1, 2025
Yes, you need to connect the blue/white wire for the PAC C2R-CHY4 amplifier. It is the remote amp turn-on wire and must be connected to the remote power wire from your head unit, whether or not you have a factory amplifier.
This answer is automatically generated
Jack E. Taylor
June 1, 2025
i don't know if i have a amp it's a 2008 jeep wrangler had a nav type. took it out putting in a alpine hook in up according to wire color but no sound
1 comments:
Mr. Anderson
June 1, 2025
The likely reason for no sound when installing an Alpine stereo in a 2008 Jeep Wrangler with a PAC C2R-CHY4 is that the original head unit uses the CANBUS to control the factory amplifier, including fade functions. Without proper communication or an added power wire to turn on the amp, the amplifier may not activate, resulting in no or very low audio output, especially from the rear speakers.
This answer is automatically generated
Jack E. Taylor
June 1, 2025
i'm putting in a standard radio a alpine ute-73bt do i need this pac
1 comments:
Mr. Anderson
June 1, 2025
If your vehicle is a compatible Dodge, Chrysler, or Jeep model and has a factory amplifier or requires navigation outputs, then the PAC C2R-CHY4 is needed to install an aftermarket radio like the Alpine UTE-73BT. It retains the factory amplifier (if equipped) and provides necessary outputs for the installation. Check vehicle compatibility to confirm.
Need help?
Do you have a question about the C2R-CHY4 and is the answer not in the manual?
Questions and answers
do i have to connect the amp blue/white wire
Yes, you need to connect the blue/white wire for the PAC C2R-CHY4 amplifier. It is the remote amp turn-on wire and must be connected to the remote power wire from your head unit, whether or not you have a factory amplifier.
This answer is automatically generated
i don't know if i have a amp it's a 2008 jeep wrangler had a nav type. took it out putting in a alpine hook in up according to wire color but no sound
The likely reason for no sound when installing an Alpine stereo in a 2008 Jeep Wrangler with a PAC C2R-CHY4 is that the original head unit uses the CANBUS to control the factory amplifier, including fade functions. Without proper communication or an added power wire to turn on the amp, the amplifier may not activate, resulting in no or very low audio output, especially from the rear speakers.
This answer is automatically generated
i'm putting in a standard radio a alpine ute-73bt do i need this pac
If your vehicle is a compatible Dodge, Chrysler, or Jeep model and has a factory amplifier or requires navigation outputs, then the PAC C2R-CHY4 is needed to install an aftermarket radio like the Alpine UTE-73BT. It retains the factory amplifier (if equipped) and provides necessary outputs for the installation. Check vehicle compatibility to confirm.
This answer is automatically generated