Cleaning And Maintenance - BorMann BFN5600 Quick Start Manual

EN
5. Swing: Press 'Swing' button to change the wind direction. The swing icon will
appear on the screen when the function is activated. Press the button again to
stop the oscillation. The vertical direction of air flow can be adjusted manually by
directing the outlet louvers up and down.is button is not available
6. Cooler: this buttom is not available.
7.Ionizer: Press 'Ion' button to activate the ionizer function. Ion icon on the screen
will light and the negative anion release will start. Anions attract to tiny particles
in the air such as dust, pollen, mold spores etc. Which cause them to become too
heavy to remain airborne. This feature let us to have dean air in the environment.
E. Operating the Water Tank
Check the level of water in the tank frequently. Be sure that water level is not
below the 'MIN' marking which is located on the water tank. Activating the 'Cool'
function with insufficient amount of water may cause malfunction of the water
pump and the warranty of your product will be void.
Before refilling water, turn your unit to 'Off' position by pressing the switch locat-
ed on the back panel and unplug the power cord.
Using the Ice Boxes
In order to increase the cooling effect of your fan, you can use ice boxes which are
supplied with the unit. Before using, place them in the freezing compartment of
your refrigerator for a few hours. Then place them into the large section of the
tank and add water to the 'MAX' level. Using the ice boxes will drop the tempera-
ture of the air flow which will create more effective cooling effect.
F. Cleaning and Maintenance
After operation for long time, the dust cumulated in the dust filter or cooling pad
may influence the inflow of air. Therefore it is recommended to clean your fan
regularly. Please follow the steps below to clean your device.
Turn off the unit and unplug the power cord before cleaning and maintenance.
1. Dust Filter
To remove the dust filter, first remove the screw, then simply press the locks with
both hands and pull it out. Use neutral cleaning agent and brush to clean the dust
and dirt on the filter. To attach the clean filter, place the bottom of the filter first
and then push upper part until it is locked tightly.
2. Cooling Pad
After removing the dust filter you can see the cooling pad. Press the lock in the
middle and gently pull out the pad. Use a clean or soft brush to remove dust and
dirt from the pad. Rinse with water if needed and leave it to dry in open air. Never
use any chemical cleaning solution that can harm pad.
3. Water Tank
Turn the water tank lock to horizontal position and pull the tank. Use soft cleaning
agents for cleaning. Wash with water and rinse the place it to its housing by push-
ing gently. Turn the lock to vertical position.
4. Exterior Cleaning
Clean the exterior case of the fan with a soft damp cloth except control panel.
Never use hard cleaning agent that can harm the case. Make sure the unit is dry
before operating it.
Caution: Never let water contact with the control panel. Always clean it with a
soft dry cloth.
4
WWW.BORMANNTOOLS.COM