Maintenance - BorMann Elite BFN5610 Manual

EN
Humidification
The humidification mode is used to increase moisture levels in the air (humidity). The ideal indoor humidity range is between 40 and 60%. If the air humidity
in your space is lower, use the appliance with the humidification function.
Caution: Use this function only when the water tank is supplied with fresh cold water.
• Turn the lock lever of the tank to a horizontal position and carefully pull the water tank out of the appliance to fill it.
• Fill the water tank with fresh cold water and make sure that the water level in the water tank does not exceed the maximum level (MАХ).
• Place the water tank back in its original position and turn the lock lever to the vertical position.
• Switch on the appliance using the ON/OFF key.
• The indicator light for the lowest speed lights up.
• Press the mode key COOLER/HUMIDIFY twice. The indicator light COOLER/HUMIDIFY lights up blue.
The speed of ventilation is always at the lowest setting and cannot be changed while using this mode.
CAUTION:
Always use fresh cold water.
Make sure the water in the water tank does not fall below the minimum level (MIN) when using the cooling or air humidification mode.
Swing Mode
Through the Swing function you can have the louvers swing automatically in a left-to-right motion for better air displacement.
• Turn the appliance on in the desired mode (cooling, ventilation or humidification).
• Press the swing button and the blades will start to move continuously in a left-to-right motion.
The vertical airflow can be adjusted manually.
Timer
The timer function can be used to switch off the appliance automatically at a required time within the range of 30 minutes to 7.5 hours.
• Press the timer key to start the timer.
• The time period increases by 30 minutes each time you press this button, up to a maximum of 7.5 hours. For example, to set the air cooler for 5.5 hours, you
must press down this key until the indicator lights for 0.5h, 1h and 4h all light up.
All indicator lights switch off when the entire programme has been completed.
If you want to stop the timer mode or set a new time, you must repeatedly press the timer key until all indicator lights are off.

MAINTENANCE

CAUTION: Always switch it off the appliance by the ON/OFF button and remove the plug from the socket before performing any maintenance task.
Cleaning the exterior
• Clean the exterior of the appliance with a damp cloth or sponge.
• If necessary, you can use a mild all purpose cleaner. Do not use aggressive or abrasive cleaning agents to clean the appliance.
• Dry the exterior of the appliance well.
Caution: Never submerge the appliance, cord or plug in water or any other liquid.
Cleaning the air filter
The air filter of the appliance can get clogged with dust and dirt. You should clean the air filter regularly to keep the air cooler working as well as possible.
• Unscrew the air filter at the rear of the appliance and remove it.
• Clean the air filter with a mild detergent in lukewarm water (approx. 40°C).
• Properly rinse the filter with clean water and allow it to air dry. Do not place the air filter in the sun or use any heating methods to dry it.
• Place the air filter back in the appliance. Check that it is fully dry, before using the air cooler again.
Cleaning the ventilation grilles
Use a vacuum cleaner with a brush attachment to clean the ventilation grilles.
Cleaning the water filter
• Remove the water filter from the appliance when removing the air filter.
• Clean it with clean water and a soft brush and then carefully place it back in the holder.
• Do not use detergents, as they can affect its quality.
5
WWW.NIKOLAOUTOOLS.GR