Installation; Unpacking; Where To Install The Water Purifier; Apply The Information Panel - Dometic RO 400 User Instructions

You should read the section entitled "Safety Information" before starting work on the actual installation of
the water purifier.

Unpacking

If the appliance has been damaged during transportation,
you should immediately notify the company responsible
for delivering it.
Take hold of the rear hand-grip and the front edge of the
water purifier and carefully lift the appliance out. The
appliance can be damaged if it is lifted in any other way.
Check the water purifier for any signs of damage and check
that no accessories are missing. If you do discover any
damage, faults or that anything is missing, you should
report this to the seller immediately. Never leave packag-
ing material in a place where children may play with it.

Where to install the water purifier

This water purifier can be installed in several different
ways. We will describe the most suitable of these. No mat-
ter which method you choose, there are certain points
which you should be careful to observe:
• The water purifier must be installed in the upright position.
• The area where it is installed must have access to a cold
water supply, a normal domestic waste pipe (drain) and
an earthed electrical supply.
• It must be easy to inspect the control panel on the
appliance.
• There must be enough space for the front cover to be
opened and for good access to the filter containers.
• When choosing the site, make sure there will be ade-
quate ventilation all around the appliance. There must
be a gap of 20 mm between the sides of the water puri-
fier and any adjacent fitments or walls. The connection
points of the water purifier allow you to route hoses
and cables in any direction out from the appliance. The
dimensions required for the installation site are shown
in Fig. A. When installing the appliance, make quite
sure that none of the service connections get crushed.
The water purifier may only be installed with the
accompanying tap. The water purifier must not
be connected so as to supply all the taps in the
property with water. There is a risk of corrosion
in water pipes and water-heaters. Neither may
the water purifier be installed in connection with
valves, switches or tanks. Any faults that arise in a
water purifier that has been incorrectly installed
are not covered by the guarantee.

Apply the information panel

In the box of accessories you will find a sheet of
self-adhesive information panels in several lan-
guages. Select the language required and apply
the printed panel to the part of the appliance
shown in Fig. B.

INSTALLATION

A
B
21