Service Repair, Maintenance And Spare Parts; Spare Parts; Disassembly And Exchange; Tools Required - Bosch Rexroth MS2S Operating Manual

40 / 50

Tools required

9.2 Service repair, mainte-
nance and spare parts
Wearing parts are reliably and professionally
repaired and replaced by the Rexroth Service in
shopfloor-oriented quality.
MS2S may only be repaired in the manufacturer
´s works or in a workshop authorized by Rexroth.
The service lives of motor components, such as
seals and bearings, may vary depending on the
operating conditions, such as operation mode,
speed, vibration and shock load, and frequent
reverse mode. We recommend to change the
bearing after 20,000 operating hours. Shorter
replacement intervals may be necessary; cf.
checks during operation . We recommend regular
visual inspections on shaft sealing rings.
Depending on operating conditions, signs of wear
may appear after 5,000 operating hours. If nec-
essary, replace the shaft sealing rings.
The Bosch Rexroth service helpdesk at our head-
quarters in Lohr, Germany and our worldwide
service provide You can contact us 24/7.
Telephone: +49 (0) 9352 40 50 60
Fax: +49 (0) 9352 18 49 41
Email: service.svc@boschrexroth.de
Internet: ⮫ https://www.boschrexroth.com
Preparing information
For quick and efficient help, please have the fol-
lowing information ready:
•
Detailed description of the fault and the cir-
cumstances
•
Information on the rating plate of the prod-
ucts in question, particularly type codes and
serial numbers
•
Your contact data (phone number, fax
number, email address)
Bosch Rexroth AG
9.3

Spare parts

Hybrid connector, size M17 (RHS1701/CM07)
Order code: R911404252
Order text: RHS1701/CM07
10 Disassembly and
exchange
10.1 Tools required
NOTICE
Motor damage due to strikes onto the motor
shaft
−
Do not strike the shaft end and do not
exceed the allowed axial and radial forces of
the motor.
Use suitable tools when disassembling transmis-
sion elements.
Pulling off
Fig. 9: Remove transmission element
Use tools suitable for pulling off. Use a shim to
protect the shaft end when using pulling-off
tools. Heat the output element, if necessary.
MS2S
R911410077, Edition 01