Setting The Time - Vitek VT-3585 SR Manual Instruction

English
screen, then you must cancel this
function first of all, otherwise the
receiver will not turn on.
2. To do so, press the electronic
lock button (2).
3. Then, after you turn off the radio
or have set the desired station,
you can set the block the receiver
using the electronic lock function,
so that incorrect commands can
not be entered. Press the
electronic lock button (2). The
symbol
screen, which ensures that the
electronic lock function has been
activated and all other button are
turned off.
Turning on receiver
1. Press the On/Off button (10) to
turn on the receiver. The power
indicator (3) will light.
2. To turn off the receiver press the
On/Off button again.
Band selection
1. Press the band selection button
(14) to switch between AM/FM.
2. To switch to the MW/SW1-10
bands, use the selector (1).
Tuner
1. To choose the desired tuner,
rotate the tuning regulator (4).
You will see the frequency
displayed on the screen.
2. If the tuning is done properly, the
radio signal will be steady. The
indicator (5) will light at the same
time.
Volume level indicator
1. You can see 16 volume levels on
the display.
M_new.indd 4 M_new.indd 4
will appear on the
2. To set the desired volume, press
the set hours/increase volume
button (8) or, accordingly, the set
minutes/decrease volume button
(9).
Backlight button
When this button (12) is pressed, the
display will light for 10 sec.
Headphones connection
To listen to radio programs in head
phones, connect them to the jack (6).
The receiver's speaker will automati-
cally turn off.
Carrying handle
The receiver is equipped with a con-
venient carrying handle.

SETTING THE TIME

Setting the current time
1. The receiver is programmed with
a 24 hour mode clock.
2. After battery installation, the
screen will show the time as
12:00.
3. Press the set time/set alarm
(MODE) button. The time on the
screen will begin to blink.
4. Then, within three seconds, press
the set hours/increase volume
and the set minutes/decrease
volume buttons to set the needed
time.
5. Setting the current time can be
done while listening to the radio.
Viewing world times
1. You can see the time anywhere in
the world when the receiver is off.
4
11.03.2009 17:04:08 11.03.2009 17:04:08