Dell U2723QE Service Manual page 14

Use a Philips-head screwdriver to tighten 4pcs
screws for locking the rear cover with the unit. Stick
S17 two pieces of label on the specific positions, then
insert 2pcs DP out Caps into the DP out connectors.
(No.1~4 screw size=M4x11; Torque=11
2
4
Take a stand base close to the monitor. Fit the two
tabs on the upper part of the stand into the grooves,
S18
and then lower the stand so that the monitor
mounting area snaps onto the stand.
Lift up the monitor to check the gap between the
front bezel and the panel, then provide power supply
S19
and a video signal to the monitor
monitor for functionality check.
5. Disassembly and Assembly Procedures
1kgfxcm)
±
3
1
, then turn on the