Panasonic KX-TG9471B Service Manual page 57

11.2.2. How to install Batch file into P.C.
1.
Insert the Batch file CD-ROM into CD-ROM drive and
copy PNZZTG**** folder to your PC (example: D drive).
2.
Open an MS-DOS mode window.
3.
At the DOS prompt, type "D:" (for example) to select the
drive, then press the Enter key.
4.
Type "CD PNZZTG****", then press the Enter key.
5.
Type "SET_COM=X", then press the Enter key
(X: COM port number used for the serial connection on your PC).
6.
Type "READID", then press the Enter key.
If any error messages appear, change the port number or
check the cable connection.
If any value appear, go to next step.
7.
Type "DOSKEY", then press the Enter key.
Note:
• "*****" varies depending on the country or models.
11.2.3. Commands
See the table below for frequently used commands.
Command name
rdeeprom
readid
writeid
setfreq
hookoff1/hookoff2
hookon1/hookon2
getchk
wreeprom
bursttx
textrx
tph
tpl
Function
Read the data of EEPROM
Read ID (RFPI)
Write ID (RFPI)
Adjust Frequency of RFIC
Off-hook mode on Base Line1 & Line2 Type "hookoff1" for Line1.
On-hook mode on Base Line1 & Line2 Type "hookon1" for Line1.
Read checksum
Write the data of EEPROM
Burst TX mode
Test RX mode
High TX mode
Low TX mode
<Example for Windows>
On your computer, click [Start], select Programs
(All Programs for Windows XP/Windows Server 2003),
then click
MS-DOS Prompt. (for Windows 95/Windows 98)
Or
Accessories-MS-DOS Prompt. (for Windows Me)
Or
Command Prompt. (for Windows NT 4.0)
Or
Accessories-Command Prompt.
(for Windows 2000/Windows XP/Windows Server 2003)
<Example>
C: Documents and Settings>D:
D: >CD PNZZTG****
D: PNZZTG**** >SET_COM=X
D: PNZZTG****>READID
00 52 4F A8 A8
D: PNZZTG****>DOSKEY
D: PNZZTG****>
<Example: error happens>
C: Documents and Settings>D:
D: >CD PNZZTG****
D: PNZZTG**** >SET_COM=X
D: PNZZTG****>READID
CreateFile error
ERROR 10: Can't open serial port
D: PNZZTG ****>
Example
Type "rdeeprom 00 00 FF", and the data from address
"00 00" to "FF" is read out.
Type "readid", and the registered ID is read out.
Type "writeid 00 18 E0 0E 98", and the ID "0018 E0 0E
98" is written.
Type "setfreq nn".
Type "getchk".
Type "wreeprom 01 23 45". "01 23" is address and "45"
is data to be written.
Type "bursttx"
Type "testrx"
Type "tph"
Type "tpl"
57
KX-TG9471B/KX-TG9472B/KX-TGA939T