KX-TG9471B/KX-TG9472B/KX-TGA939T
8.3.
How to Clear User Setting
Units are reset to the Factory settings by this operation (Erase recorded voice messages, stored Phone numbers, Caller list and
etc.)
Note:
• Some menus are not reset. Refer to Operating Instructions (P.18).
• The reset menus differ depending on the following operations.
• This operation should not be performed for a usual repair.
8.3.1.
Resetting both base unit and portable
Both the base unit and the registered portable which you did the following steps
will not be reset.
w
1
Connect the AC adaptor to the base unit and install the charged batteries into the portable.
2
Confirm the portable is registered to the base unit (
If the portable is not registered to the base unit (
3
Lift the portable and press {OFF} to put the portable in standby mode.
4
1
5
9
Press
,
,
and
5
Disconnect the AC adaptor, then remove the battery.
Note:
(*1) Refer to Registering a Portable to the Base Unit (P.18).
8.3.2.
Resetting only portable
The only portable is reset by doing the following steps
1
Install the charged batteries into the Portable.
2
Lift the portable and press {OFF} to put the portable in standby mode.
3
3
5
7
Press
,
,
and
4
Remove the battery.
Note: (*2)
• The portable registration to the base unit is cancelled.
• If the portable needs to be registered to the base unit, refer to Registering a Portable to the Base Unit (P.18).
• If users do not bring the base unit with them, the registration procedure has to be done by users themselves.
Portable
key of the portable simultaneously until a confirmation tone is heard.
to
Portable
#
key of the portable simultaneously until a confirmation tone is heard. (*2)
to
Base unit
lights).
is flashing), register it. (*1)
.
26
are reset. Other registered portables