Advertisement
Rear Panel
INPUT
12
FS/IN
MIDI
(12) MIDI OUT
When functions are toggled from the front panel or footswitch, the corresponding MIDI information is
transmitted from this jack to synchronize the function with a slave TE1200. The connection is made from this
jack to the slave's Footswitch jack with a standard 5-pin MIDI cable. (The 8-pin Footswitch jack will accept the
5-pin cable.)
NOTE: The master unit will generate controller messages for this synchronization. It will also act as
a MIDI THRU for program change and controller messages on any channel meant for other devices,
but not ALL messages. Put the TE1200 last in line if other units in your MIDI chain need sysex and/
or other MIDI messages.
(13) Footswitch
Connect the TE1200 4-button footswitch here for parallel control of the front panel switch functions. The
8-pin cable must be used with the footswitch to provide power and bi-directional data. This jack also functions
as a standard MIDI input using a 5-pin cable. This allows you to control the TE1200 with other MIDI sources
(MIDI automation, another type of footcontroller, or a master TE1200). It will respond to the controller
messages shown below - on MIDI channel 1. Data values from 0-63 (0-0x3F in hexadecimal) will be considered
OFF, while 64-127 (0x40-0x7F in hexadecimal) will be considered ON.
01:
Effects Loop (e.g. B0 01 00 for off ... B0 01 7F for on)
02:
Pre-Shape
03:
Compressor
04:
Mute
05:
EQ pre-Compressor
(14) USB RECORD OUT
This is provided for connection to a computer or a digital audio workstation for recording. It is the preamp
master out signal which includes all preamp functions. There is no input capability.
(15) TUNER OUT
A direct send from the input circuitry for a tuner. It is not processed and is fully buffered. It remains active even
when the amp is muted - for silent tuning.
(16) DIRECT OUT (DI)
This is a balanced output to send to a mix console or analog recording device. It has a switch that selects
whether the output is before or after the EQ.
6
BASS
14
15
OUT
TRACE ELLIOT
TE 1200
DESIGNED IN
TUNER OUT
THE UK and U.S.A.
MADE IN CHINA
PRE
POST
EQ
LIFT
GND
DIRECT
OUT
GND LIFT
USB
D.I. (DIRECT INTERFACE)
REC OUT
13
17
16
PRE
EQ PRE/POST
COMPRESSOR
LO-MID
HI-MID
18
19
HI
®
LO
®
EFX LEVEL
SPEAKER
JACKS
PARALLELED
PREAMP
SEND
OUT
CLASS 2 WIRING
POWER AMP
RETURN
IN
SPEAKER OUTPUTS
20
ON
PRE-SHAPE
TREBLE
21
22
24
POWER
100-120V
T10AH/250V
220-240V
T5AH/250V
FUSE
4 MIN 69.3VRMS
FOR 100-120V~ USE T10AH/250V FUSE
220-240V
1200W RMS 4 OHMS
FOR 220-240V~ USE T5AH/250V FUSE
100-120V
50/60 Hz 150 WATTS
Consumo de energia 150Wh
23
25
PHONES
ON
Advertisement
