Advertisement
Running your SD40 in the TrainMaster Command environment
address Locomotive #1
PowerMasters set to
CMD or traditional
power supplies ON FULL
Press ENG
Press 1 (the ID#)
CAB-1 commands for your SD40
Front coupler
releases.
c
oupler releaSe
Rear coupler releases.
c
o u p l e r
r e l e a S e
.
SounDS
Activates keypad.
Press AUX2 to turn
your SD40's head-
light on and off.
Turn the THROTTLE
to the right to accel-
erate, left to deceler-
ate.
Press HALT to shut
down all Power-
Master electrical out-
put on your railroad.
Stops all Command-
equipped Lionels in
operation.
Y
our Command-equipped SD40
comes factory-programmed with
an ID# of "1." To get your SD40 in
action, set PowerMasters to CMD or set
all power supplies on full. Press ENG
and "1" on CAB-1. Turn the throttle or
press any command button; your SD40
is ready for Command operations.
Press WSTL/HRN to activate
the SD40 horn & oscillating
ditch lights. release it to dis-
continue. m
h
ulti
orn DieSel
. F
horn SounD
ront oScillat
ing Ditch lightS in pilot
Press BELL once to activate
the bell, again to discontinue.
D
i e S e l m e c h a n i c a l B e l l
.
SounD
Press DIR—the locomotive
decelerates to a complete stop;
turn the throttle up, and the
locomotive will accelerate in
the new, opposite direction.
t
here iS no neutral State
-
.
air
releaSe SounD
Press and hold BOOST for extra
power. Release BOOST and
return to the SD40' s previous
speed.
Press and hold BRAKE to slow
down or stop. Release
BRAKE and return to the previ-
ous speed. S
quealing Brake
.
SounDS
-
.
. D
ieSel
9
Advertisement
