HomeSeer HSM200 User Manual

HSM200 User Guide
Online manual for the HSM200 Z-Wave Multi-sensor
Overview
HSM200 is a Z-Wave multi-sensor that reports motion, temperature and light level using wireless Z-Wave commands. The product includes electrical
prongs and is designed to plug into, and be powered by a standard US 120V wall outlet. HSM200 also includes an RGB LED that may be controlled
by Z-Wave commands. This feature allows users to change the color of the LED to reflect the status of things in their home. The unit has been
designed, tested and certified for use in the United States and Canada.
Installation
HSM200 is designed to plug directly into a 120V US outlet or it may be attached to an extension cord.
Configuration
Z-Wave Inclusion or Exclusion
1. Put your Z-Wave controller into inclusion (or exclusion) mode. Consult your controller's manual if you're unsure how to do this.
2. Press the small button on the side of the HSM200 to initiate inclusion (or exclusion).
The LED will blink blue rapidly indicating HSM200 attempting to join a Z-Wave network. Once HSM200 been added to the Z-Wave network, the LED
will stop blinking blue and instead will blink white each time it detects motion. HSM200 will remain in this mode for 5 minutes. Once the 5 minutes has
expired, HSM200 will enter normal operating mode and the LED will remain off. Pressing the push button will restart the 5 minute motion detector test
mode.
Factory Reset
To be used only in the event that the network primary controller is lost or otherwise inoperable.
1. Press and hold the pairing button for 60 seconds.
The LED will blink blue and then shift to yellow and continue to blink rapidly. Once the LED turns off, HSM200 is reset to factory defaults and will blink
cyan indicating it is ready to be added to a Z-Wave network. All configuration parameters will be reset to their default values.
Association
This product supports Group 1 and Group 2 Associations with up to five Z-Wave devices per group. Group 1 supports Lifeline Communication, Group
2 supports Basic Set, refer to your controller manual for instructions on setting up these features.
Operation
HSM200 will send these Z-Wave commands
Motion is sensed
sends report to the hub
sends on, off or dim command to associated Z-Wave devices (like bulbs or switches)
Motion is no longer sensed
sends report to the hub
sends off to associated Z-Wave devices (like bulbs or switches)
Temperature report
sends report to the hub
Luminance report
sends report to the hub
HSM200 will receive these Z-Wave commands from the hub