WilTec 50144 Operation Manual page 7

Step 4-1
№
Name
1 Hopper
23 Slot
Turn the hopper (1) upside down and push the slot (23) completely into the guide channel on the un-
derside of the hopper.
Step 5
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
№
Name
1 Hopper
21 Screw M6×40
16 Small flat washer
18 Hex nut M6
3 Spinner disc
20 Release pin
19 Screw M6×55
17 Lock washer
Fasten the hopper (1) to the supports (5, 6, 7)
with the M6×40 screw (21), small washer (16)
and hexagon nut (18). Fasten the hopper to the
spreading disc (3) with the release pin (20).
Fasten the control cable (1-1) to the front
bracket (9) with an M6×55 screw (19), a small
flat washer (16), a lock washer (17) and a cable
lock nut (22).
Note! The control cable (1-1) comes pre-
installed on the hopper.
Item 50144
Quantity
1
1
Qty.
1
4
5
5
1
1
1
2
Page 7
09 2021-1