Advertisement
Quick Links
Operation Manual
Push Broadcast Spreader
50144
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificant-
ly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 50144
Summary of Contents for WilTec 50144
- Page 1 Operation Manual Push Broadcast Spreader 50144 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificant- Updating the documentation If you have suggestions for improvement or have found any irregularities, please contact us.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Do not use the spreader near other people or animals. • Only use the spreader at walking pace. • Do not use the spreader in rain or strong wind. Never leave it out in the rain. © by WilTec Wildanger Technik GmbH Item 50144 Page 3 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 4 Rear hopper support Hex nut M6 Right hopper support Screw M6×55 Left hopper support Release pin Split bushing Screw M6×40 Front bracket Cable lock nut Axle Slot © by WilTec Wildanger Technik GmbH Item 50144 Page 4 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 5 (6) and the left hopper sup- port (7), using the M6×50 screw (14), small washer (16) and hexagon nut (18) as shown in the figure above. © by WilTec Wildanger Technik GmbH Item 50144 Page 5 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 6 Insert the cotter pin (11). Place the second wheel (2) on the right side of the axle (10) and secure it with the M6×50 screw (14), small washer (16) and hexagon nut (18). © by WilTec Wildanger Technik GmbH Item 50144 Page 6 http://www.WilTec.de http://www.aoyue.eu...
- Page 7 (9) with an M6×55 screw (19), a small flat washer (16), a lock washer (17) and a cable lock nut (22). Note! The control cable (1-1) comes pre- installed on the hopper. © by WilTec Wildanger Technik GmbH Item 50144 Page 7 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 8 (16) and a hex nut (18). Important: Reprinting, even in part, and any commercial use, including parts of the manual, only with the written consent of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 50144 Page 8 http://www.WilTec.de...