Table of Contents
Advertisement
•
•
•
For more information about RUGGEDCOM ELAN, visit
industrial-communication/en/rugged-communication/ruggedcom-portfolio/soft-
ware/Pages/elan.aspx.
1.9
Default IP Addresses
Based on the software platform installed on the RUGGEDCOM APE, the IP addresses
for the front and/or internal ports may be pre-configured or set dynamically by the
Dynamic Host Configuration Protocol (DHCP).
Software Platform
Windows® Embedded Standard
7
Debian Linux®
Check Point GAiA™ OS
1.10
RUGGEDCOM APE Ethernet and Network Settings
The RUGGEDCOM APE is essentially a two-port industrial computer. When the
RUGGEDCOM APE is inserted into a chassis, the first internal Ethernet port is acti-
vated on the connector that carries power to to the RUGGEDCOM APE. The second
RUGGEDCOM APE Ethernet port is available for use on the faceplate of the RUGGED-
COM APE line module.
To the RX15xx device, the RUGGEDCOM APE internal Ethernet port appears like any
other Gigabit-capable switched or routed port.
For examples of how the RUGGEDCOM APE can be configured in a RX15xx device, re-
fer to
ple: RX15xx Services and WAN Networking (Page
1.10.1
Example: Networking in Factory Default Conditions
The following figure illustrates how routing and switching would work when the
RUGGEDCOM APE is used in a RUGGEDCOM RX15xx chassis with a four-port Ethernet
module in LM2.
RUGGEDCOM APE (Application Processing Engine)
Configuration Manual, 12/2019, C79000-G8976-1121-05
Powerful automation processor
Reliable extraction/presentation of relay target data
Wide range of security options
"Example: Networking in Factory Default Conditions (Page 7)"
External Port (RJ45)
DHCP
DHCP
Not Configured
9)".
1.9 Default IP Addresses
http://w3.siemens.com/mcms/-
Internal Port
DHCP
DHCP
169.254.100.100
and
"Exam-
Overview
7
Advertisement
Table of Contents
