AIR-EAGLE
2.4 GHz RF Transceiver
MODEL 36-6000-DC
DESCRIPTION
The A
-E
SR PLUS TRX is an R.F. transceiver capable of
IR
AGLE
transmitting and receiving commands from up to 600 feet away. This
model comes equipped with three dry contact inputs and two 5amp
relay outputs. When combined with another transceiver this allows the
user to transmit information out and receive a confirming signal back
that the operation was performed. This unit has eight user-selectable
network frequencies to allow multiple systems to operate
simultaneously in the same area without interference.
INSTALLATION
DISCONNECT Power from all equipment before installation.
1.
Mount the control unit in a convenient location.
2.
Install control wiring to terminal strip.
3.
Make desired relay, channel code and frequency selections using
instructions on page 2.
4.
Attach antenna to TNC connector located on the right side on the
enclosure.
5.
Connect supplied power input cable to your external source.
PC BOARD SET-UP INFORMATION
Make the following connections on the PC Board Terminal Strip (TER1)
TERMINAL STRIP WIRING (TER1)
Terminal 1
Negative (-) 9-36VDC INPUT
Terminal 2
Positive (+) 9-36VDC INPUT
Terminal 3
CH1 Dry Contact Input (Common)
Terminal 4
CH1 Dry Contact Input
Terminal 5
CH2 Dry Contact Input (Common)
Terminal 6
CH2 Dry Contact Input
Terminal 7
CH3 Dry Contact Input (Common)
Terminal 8
CH3 Dry Contact Input
Terminal 9
CH1 Relay N/O
Terminal 10
CH1 Relay C
Terminal 11
CH1 Relay N/C
Terminal 12
CH2 Relay N/O
Terminal 13
CH2 Relay C
Terminal 14
CH2 Relay N/C
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
SR PLUS
PRODUCT INFORMATION
BULLETIN
CONTROLS & INDICATORS
Illuminates Green when power is applied,
POWER/TX LED
changes to Red when transmitting.
Green LED illuminates continuously while relay
LED1
#1 is energized
Green LED illuminates continuously while relay
LED2
#2 is energized
CH1 – CH3 Dry
Transmit individual RF codes to the remote
Contact Inputs
transceiver
REL1 & REL2
Two SPDT output control relays
RF Module that transmits/receives data for
RF1
corresponding unit