BWI Eagle AIR-EAGLE XLT PLUS 461-8000-VBR-AC Product Information Bulletin

AIR-EAGLE
High Power 900MHz RF Receiver
MODEL 461-8000-VBR-AC
DESCRIPTION
The A -E XLT P is an RF system designed for long range
IR AGLE LUS
wireless remote control of electrical apparatus in a variety of industrial
applications. Systems can consist of any number of receivers and
handheld or contact input transmitters working together. The "461" series
of receivers feature built-in repeating capability. They will listen for all
transmissions from the control transmitter, perform commands if
necessary and pass all commands on to any receiver within range. This
receiver is equipped with 4 independent relays capable of switching 5
amps @ 120VAC or 30VDC, which can be directly interfaced with the
customer's equipment or P.L.C. Eight user selectable frequencies allow
multiple systems to be used in the same area. The Air-Eagle XLT Plus
can receive remote signals transmitted from up to 5000 feet away (with a
handheld transmitter) or up to 10 miles away (with a stationary transmitter
and external high gain antennas.
MODEL NOTES
This receiver was designed specifically to communicate with a "VBR"
transmitter and features a confirmation signal that is sent back to the
transmitter causing it to vibrate when its transmission has been received.
INSTALLATION
Mount the A -E XLT PLUS RECEIVER
1. IR AGLE
location.
2. Install relay control wiring to the terminal strip.
3. Attach rubber duck antenna or coax from external antenna to
connector on side of enclosure.
4. Connect supplied power input cable to your external power source.
TERMINAL STRIP WIRING (TER1)
Terminal 1 100-250 VAC Power Input
Terminal 2 100-250 VAC Power Input
Terminal 3 CH1 Dry Contact Input (Common)
Terminal 4 CH1 Dry Contact Input
Terminal 5 CH2 Dry Contact Input (Common)
Terminal 6 CH2 Dry Contact Input
Terminal 7 N/O Relay 1
Terminal 8 C Relay 1
Terminal 9 N/C Relay 1
Terminal 10 N/O Relay 2
Terminal 11 C Relay 2
Terminal 12 N/C Relay 2
Terminal 13 N/O Relay 3
Terminal 14 C Relay 3
Terminal 15 N/C Relay 3
Terminal 16 N/O Relay 4
Terminal 17 C Relay 4
Terminal 18 N/C Relay 4
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
® XLT PLUS
a convenient
IN
These inputs
are not active
on the
standard
model
PRODUCT INFORMATION
BULLETIN
CONTROLS & INDICATORS
Dual color LED. Illuminates red while receiver is
booting up; changes to green when boot-up is
POWER/TX
successful and unit is ready to operate. If this LED
LED1
fails to turn green, power unit off for 15-20
seconds, then reapply power.
LED2 Illuminates green while relay 1 is energized
LED3 Illuminates green while relay 2 is energized
LED4 Illuminates green while relay 3 is energized
LED5 Illuminates green while relay 4 is energized
REL1 – REL4
Four SPDT output control relays
RF1 RF Module that transmits/receives data