Installation And Electrical Installation; Installation; Electrical Installation - Scholl 24000/B/C Instructions For Use Manual

GBA B 0041 4 E
4 I
NSTALLATION AND ELECTRICAL INSTALLATION
4.1 I
NSTALLATION
Before the installation of the appliance, observe the following:
 Inspect the unit for any defect or damage sustained in transit.
 Check all screw connections for tightness.
 Familiarize yourself with the Instructions for Use and with the conditions for the safe operation of this
appliance.
 Clean the unit before the first use according to chapter "Cleaning and care".
 Place the unit at a suitable location.
4.2 E
LECTRICAL INSTALLATION
The appliance may only be installed by a qualified electrician whilst taking into
account the applicable regulations!
Connect this appliance to suitably earthed mains outlets only. Ensure that your
mains power supply conforms to the data stated on the nameplate of the appliance.
Failure to observe this warning may result in a fire hazard or electrical shock!
Before putting the appliance into service, observe the following:

Faulty equipment must not be taken into operation!
 Legal requirements and the connection conditions of your local power supply company must be fully
observed.
 Electrical safety functions must be carried out and checked for operability.
 Full protection against electric shock hazard must be ensured by the installation.
 This device is protection class I, the mains connection line has a protective conductor.
 Buffet heat lamp B 0051, B 0052, B 0054:
A switch according to the valid standards must be installed on site to ensure complete disconnection of
the fitted unit from the mains.
 Buffet heat lamp B 0061, B 0062, B 0056:
A freely accessible separating device (e.g. switch with at least 3 mm contact opening width) must be in-
stalled on site to ensure complete disconnection from the mains.
 This device is equipped with a mains connection line with plug.
This device must be set up so that the plug is freely accessible; otherwise, an on-site upstream separat-
ing device (e.g. switch with at least 3 mm contact opening width) must be installed to ensure complete
disconnection from the mains.
BA
Last revised 03-2019
Page 11 of 33 März 21, 2019
Rev. 4